Synthetic resin-bonded mounted points for machining stainless steel

6 mm shank; synthetic corundum in synthetic resin bond; medium-hard bond; working speed for sanding edges 40-50 m/s, for sanding surfaces 40-50 m/s

Field of Application:

Degree of hardness 0: Recommended circumferential speed when sanding edges is 24-40 m/s and 15-25 m/s when sanding surfaces. These circumferential speeds are recommended for the indicated hardness levels.
Please observe the specified rotation speeds on the enclosed information slips. The circumferential speeds are indicated by green diagonal lines in the diagram. The vertical line corresponding to the tool diameter crosses the diagonal circumferential speed (diagonal line). From there, the rotation speeds (in rpm) of the sanding tool and machine can be read off by drawing a horizontal line to the left edge

Type:

ZY 2032

Advice:

Example:
Mounted point dia. 20 mm
recommended circumferential speed, for degree of hardness 0 = 15-40 m/s, see table for the rotation speeds: 14,000-38,000 rpm
For materials that are difficult to machine, lower circumferential speeds are recommended as this enhances the sanding properties of the mounted point. The broad range of grain types and degrees of hardness allows all sanding work to be optimised.