The special anchor for mounting in external thermal insulation composite systems (ETICS)

This insulation anchor is a mounting solution developed for ETICS (external thermal insulation composite systems)
with insulation thickness greater than 100 mm. Pipe clamps
and other components with an M10 female threaded connection are mounted on the RECA ID 95 VM
insulation anchor. These clamps are then used to mount downpipes for
roof drainage. The RECA ID 95 VM insulation anchor is equipped with a
drill tip. This makes it possible to mount it directly after plastering without
pre-drilling into most ETICS (external thermal insulation composite systems) made from rigid foam panels, polystyrene panels,
Styrofoam panels, Heraklith panels and wood fibre insulating panels
(pre-drilling to 14 mm required). The M10 set screw is freely selectable depending on the requirement.
The screw-in depth into the anchor is min. 20 mm to max. 50 mm.
The moulded cover cap guarantees a clean connection and is
also fitted with an EPDM seal to protect against moisture.

Application area:

For mounting downpipe clamps, signs, lighting and other components in
external thermal insulation composite systems (ETICS) e.g. rigid foam panels, expandable polystyrene panels, Styrofoam panels, Heraklith panels and in wood fibre insulating panels
(pre-drilling to 13 mm required)

Field of Application:

For mounting pipe clamps and other components in
external thermal insulation composite systems made from rigid foam panels, polystyrene panels,
Styrofoam panels, Heraklith panels and in wood fibre insulating panels (pre-drilling to
13 mm required)

Advantages:

• The perfect solution for mounting downpipe clamps in ETICS: easy, flexible, fast and adjustable
• Thermal bridge-free mounting directly in the insulation material
• Integrated sealing washer made of weather-resistant rubber, no additional sealing necessary
• No pre-drilling Robust, self-drilling (ETICS plaster ≤ 7 mm) nylon dowel
• Suitable for use with threaded rods or anchor rods

Content remark:

Loose, without set screws

Advice:

• Remove an area of plaster or other surface material from the substrate in the size of the wall plug collar (see table). Screw the anchor in until flush using low torque without pre-drilling