Vit dagføra vøruupplýsingarnar. Vit fara ígjøgnum allar vørulýsingarnar í vørusavninum. Upplýsingarnar um nýtsluøki og tilfar, sum vøran kann brúkast til, kunnu vera skeivar, meðan vit skráseta rætta tilfarið fyri hvørja vøru. Ert tú í iva, spyr tín kontaktpersón hjá A4.
- Hástyrkistál (Hardox)
Suitable for HARDOX® 500 (for HARDOX 550 preliminary testing is required) and for very hard materials up to 1700 N/mm² such as excavator shovels, lorry superstructures, snowploughs, agricultural machines, armour plating etc. Materials up to 1400 N/mm² can be processed using hand drills.
The drill bit for the toughest materials For hand drills and stationary power tools, DIN 338 type H, right-hand cutting, ground, multi-layer (Ti AlN)-ZrN coating, HSS-Co 8%
Fyrimunir
- 135° turbo cutter with cross thinningPrecise tappingNo centre punching necessaryOptimal drilling progressDrilling on curved surfaces
- Robust, sturdy and long-lastingHSS-Co 8% - M42 cutting material — extremely long service lifeShort groove with reinforced core — maximum stabilityNarrow drill heel for the lowest friction resistance — robust — low risk of breakage
- Surface coatingMulti-layer ZrN coating (zirconium nitride)Increased surface hardnessPrevents built-up edgesEnhances thermal stability
Góð ráð
- Prerequisites for drilling HARDOX®:
- Stability is crucial. Hand drills are not suitable for drilling Hardox.
- Minimise the distance between the drill bit and the workpiece and clamp the workpiece firmly.
- Reduce the feed rate shortly before drilling through and ensure recommended feed rate and cutting speed are maintained.
Faklig nærlýsing
| Angle of the tip | 135 Degree |
| Chip flute length | 51 mm |
| Coating | TiAlN |
| Cutting material | HSCo8 |
| Diameter | 12.0 mm |
| Length | 151 mm |
| Material to be processed | Highly heat-resistant alloys |
| Surface | Coated |
Væntað veiting: 29.–30. sep.
Bílegg í seinasta lagi mikudagin kl. 23:59 · bíleggingin verður send til Reca hósdagin
EXTREME Plus twist drill bit DIN 338 HSS-Co 12.0 mm
The drill bit for the toughest materials For hand drills and stationary power tools, DIN 338 type H, right-hand cutting, ground, multi-layer (Ti AlN)-ZrN coating, HSS-Co 8%
| Vørunummar | 0617800120 |
| EAN | 4029484945542 |
| Pakkieind | 1 stk |
| Angle of the tip | 135 Degree |
| Chip flute length | 51 mm |
| Coating | TiAlN |
| Cutting material | HSCo8 |
| Diameter | 12.0 mm |
| Veitari | RECA NORM |