1 / 3
Updated product information. We are reviewing every description in the catalogue. The application area and the materials listed may be incorrect while we set the correct materials on all articles. If in doubt, ask your contact at A4.
Field of Application
Materials
- Steel
- Cast iron
- Plastics
Precision drill bit for drilling steel up to 1,000 N/mm² and cast steel (alloyed and unalloyed), grey cast iron, malleable iron, spheroidal graphite iron, sintered iron, nickel silver and graphite.
Description
Twist drill bit with TRICON shank, short, type N, right-hand cutting, split point, DIN 338, HSS
Advantages
- 118° cutting edge with split point
- Precision tapping - no centre punching; precise dimensional accuracy - accurate drill holes; low feed rate and cutting forces - energy-saving operationBlue ring - for steel
- Simple material allocation - no mix-ups; suitable for machine taps and countersinksOxide heat treatment, copper/plain
- Reduced thermal load on the drill bit
- Oxide-treated drill bit bevel for maximum service lifeTRICON shank for mechanical-interlock power transmission
- No spinning in the drill chuck - optimal power transmission/no groove formation; excessively deep clamping in drill chuck is avoided - optimal elasticity; low energy expenditure when opening and closing the drill chuck - protects your drill chuck
Advice
- From 4.0 mm with TRICON shank
Composition of set
1.0–13 mm 1.0–5.0 per 2 pcs. 5.5–13.0, 1 piece each
Technical specifications
| Angle of the tip | 118 Degree |
| Ascending | 0.5 mm |
| Composition of set | 1.0–13 mm;1.0–5.0 per 2 pcs.;5.5–13.0, 1 piece each |
| Cutting material | HSS |
| Material to be processed | Plastic |
| Number of pieces | 34 PCS |
In stock
ultra steel HSS twist drill set, DIN 338, 1.0–13.0 mm
Twist drill bit with TRICON shank, short, type N, right-hand cutting, split point, DIN 338, HSS
| Article number | 0617004913 |
| EAN | 4029484830572 |
| Pack unit | 1 pc |
| Angle of the tip | 118 Degree |
| Ascending | 0.5 mm |
| Composition of set | 1.0–13 mm;1.0–5.0 per 2 pcs.;5.5–13.0, 1 piece each |
| Cutting material | HSS |
| Material to be processed | Plastic |
| Supplier | RECA NORM |