Advantages

• European Technical Approval (ETA-09/0301)
• Concealed fastening produces a high-quality finish
• High load-bearing capacity coupled with low installation depth (14 mm)
• Conical, swallow tail-style geometry for self-centring and gap-free contact pressure
• A high level of pre-fabrication is possible in the workshop, for quick and easy on-site installation

Advice

• It is advisable to use the corresponding milling template set for easy and quick pre-assembly (art. no. 0681 003 001). Using the template, the milled recess is produced at the required point on the main beam. The milling depth is 14 mm. The lower part of the connector is screwed into it. The counterpiece must be screwed into the end grain at an angle of 35°. The screw angle is determined by the shape of the tabs. Milling is not necessary in this respect. Screwing is performed with 5.0 x 80 mm full-thread screws (art. no. 0681 003 010) in accordance with EN 14592.
• Installation instructions:
• 1. Secure the template to the beam using the fixing holes.
• 2. Set milling cutter to 14 mm milling depth. The stop ring prevents
• damage to the template.
• 3. Mill out recess.
• 4. Remove template and insert base of connector.
• 5. Attach upper part of connector to secondary beam at centre. To do so, first position the centring screw,
• then screw in the remaining screws at an angle of 35°.
• 6. Hang secondary beam from above.

Technical specifications